Dutton-Lainson Company

Class 1 (2000 lb) coupler with pin & chain, fits 3 inch tongue. Zinc TUFFPLATE finish.

Ground Fault Circuit Interrupter for 120 volt AC electric winch applications near water. 15 foot 14/3 cord, 15 amp, 125 volt. Breaker mounted 7-1/2 inches from plug.

15 foot winch strap with hook, with breaking strength of 2600 lbs, for DL1100A through DL1602A (strap rating must be 150% of winch rating). 2 inch width, includes 3/8 inch bolt and nut. Note: Installing strap on smaller winches DL600A and DL900A requires a 1/4 x 2.75 inch bolt, which is not included.

120 Volt Electric Winch has 10 foot, 3 wire grounded power cord. 1200 lb capacity. Power in, power out, controlled freewheeling clutch, and automatic brake. Comes loaded with 20 ft of 3/16 aircraft cable. Emergency crank handle also included in case of power loss. For applications with access to AC power: Boat lifts; Boat davits; Frame-straightening machines (to pull disabled vehicles up onto machine); Light towers; Marine railway systems; Greenhouse ventilation systems; Aircraft hangars (to pull small aircraft in and out); Opening/closing large horizontal sliding doors; Dumb waiters; General material handling applications. What makes StrongArm® electric winches different? Design: -is more compact, allowing it to fit into tight spaces. -is safer, as cable is enclosed inside the cover. On open-reel models, fingers can get caught in cable as it’s reeled in, and any frayed strands can cause cuts. -protects cable, so it’s not exposed to the elements, which accelerates wear and rusting. Unique features: -Clutch release. User can pay out load in neutral and still control it with clutch mechanism. -Spur gear system vs. planetary gears. A planetary gear system generates much more heat, and draws more amps from the power source. Because the motor and gears are attached directly to the spool, the heat build-up from running the winch transfers directly to the drum and cable. In contrast, the StrongArm winch’s spur gear system is much more efficient, it gives off less heat and draws fewer amps. NOTE: THIS WINCH IS BUILT FOR HORIZONTAL PULLING. FOR VERTICAL LIFTING APPLICATIONS, WE RECOMMEND ORDERING A WINCH WITH NO CLUTCH INSTALLED. PRICE IS THE SAME. NOTE: MAXIMUM RUN TIME 3 MINUTES. SEE OWNERS MANUAL FOR MORE DETAILS.

Model 6399 2 inch coupler ball, similar to model 6397, but with longer shank for thicker bumpers. Shank is 3/4 inch diameter, 2 inches long.

GOLDENROD heavy duty pump oiler, built to last. Precision machined, replaceable parts throughout; screw cap filler opening, interchangeable spouts, zinc die-cast high pressure pump with precision machined piston. Delivers a drop or stream of oil and stays primed for instant use. Powder coated copper bronze finish. Quart size, with 11 inch angle spout.

Spring bottom oiler - just press on the bottom of the container to dispense fluid. 12 oz, with flexible spout.

Pump oiler with wide base for stability. Zinc die-cast high pressure pump with precision ground piston. 10 oz, with straight spout. Powder coated copper bronze finish.