Dutton-Lainson Company

6 oz oiler with straight spout. Plastic container, gray color.

Similar to 10970, but has the ability to accept a 2 inch wide winch strap. Reel has matching holes drilled in each side plate. Crank the reel so that the hole is outside of the edge of the base, and bolt can be inserted. A wrench or needle-nose pliers are necessary to hold the nut in position on the opposite side during mounting. The bolt goes through a loop in the end of the strap. Powder coated black finish. Handle included. 2000 lb capacity. Straps sold separately, see Hand Winch Accessories. Recommended strap is model 6249, 20 foot, item 24240.

Brake winch safety and rugged construction at a more economical price. Raise and lower loads with minimal effort, with load locked in place, even when handle is released. 350 lb capacity, zinc TUFFPLATE finish. 50 lb minimum load required for winch to operate properly. Handle included.

5-foot roller bunks (pair) attach directly to vertically-mounted 2 x 4 bunk boards, or can be mounted with 6356 brackets (sold separately). A quick, easy and inexpensive way to upgrade bunk trailers to rollers. 14 gauge steel, black powder coated finish, rubber rollers. For boats weighing up to 3000 lbs. The advantage of this style of roller bunks is that each set of rollers has some wobble capabilities (up to roughly 10 degrees), providing some self-alignment with the boat hull. The rated capacity is based on having good contact with all of the rollers, and a reasonably even distribution of weight on the rollers. Rollers must be in contact with straight sections of the boat hull. It is critical to avoid a very large load on the first set of rollers during the unloading and loading process. The boat should float at least part way onto the trailer before contacting rollers, so that all of its weight is not concentrated on the first set of rollers. A concentrated load can crush a single set of rollers, with the potential for damage to the boat hull.

3/4 inch spindle O.D., 1.938 outer hub I.D. Cone nbr 09067, cup nbr 09195. Includes 2 bearings with races, 1 grease seal and cotter pin. IMPORTED.

Heavy duty Class 1 welded link chains for trailers up to 2000 lbs. Zinc plated finish to resist rust, with heavy steel hook and safety clip that latches to keep chains attached to tow vehicle. Chain size 3/16 inch, mount with 3/8 inch bolts. Meets SAE and V-5 standards. Two 24-inch chains per package. NOTE: Do not mount chains to trailer tongue with the same bolts used to mount coupler. Cross safety chains under coupling, allowing only enough slack for turns.

Side handle for jacks with 2 inch outer tube with date code after 4296 (week 42 of 1996). Includes roll pin and bushing. For use with D-L tongue jacks only.

Model 6630 Ag-Industrial jack, top wind, with 10 inch travel. Includes weld-on mounting tube, and detent pin. 2000 lb capacity. Powder coated black finish.