Dutton-Lainson Company

12 Volt Electric Winch with factory-installed remote control (handheld pendant switch with 10 ft cord) is powered by your vehicle battery, using wiring harness (included). Power in, power out, controlled freewheeling clutch, and automatic brake. Comes loaded with 50 ft of 3/16 aircraft cable, pulley block and snap hook. 2200 lb load capacity when double-lined. Emergency crank handle also included in case of power loss. DC Winches are great for mobile applications, or around water. Mount on ATV’s; Race car trailers (also for moving extra tires); Antique car trailers; Boat trailers; Hay bale moving; Livestock feeding equipment; Large livestock trailers; Boat lifts; Articulating conveyors. What makes StrongArm® electric winches different? Design: -is more compact, allowing it to fit into tight spaces. -is safer, as cable is enclosed inside the cover. On open-reel models, fingers can get caught in cable as it’s reeled in, and any frayed strands can cause cuts. -protects cable, so it’s not exposed to the elements, which accelerates wear and rusting. Unique features: -Clutch release. User can pay out load in neutral and still control it with clutch mechanism. -Spur gear system vs. planetary gears. A planetary gear system generates much more heat, and draws more amps from the power source. Because the motor and gears are attached directly to the spool, the heat build-up from running the winch transfers directly to the drum and cable. In contrast, the StrongArm winch’s spur gear system is much more efficient, it gives off less heat and draws fewer amps. NOTE: THIS WINCH IS BUILT FOR HORIZONTAL PULLING. FOR VERTICAL LIFTING APPLICATIONS, WE RECOMMEND ORDERING A WINCH WITH NO CLUTCH INSTALLED. PRICE IS THE SAME. NOTE: MAXIMUM RUN TIME 4 MINUTES. SEE OWNERS MANUAL FOR MORE DETAILS.

Similar to 25720, but NO CLUTCH, so no freewheeling capability. Suitable for short-distance vertical lifting applications not involving people, or loads over where people could be present. NOTE: MAXIMUM RUN TIME 4 MINUTES. SEE OWNERS MANUAL FOR MORE DETAILS.

Brake winch safety and rugged construction at a more economical price. Raise and lower loads with minimal effort, with load locked in place, even when handle is released. 1500 lb capacity, powder coated copper bronze finish. 75 lb minimum load required for winch to operate properly. Handle included.

Model 6343 5 In Spool Roller - Fits 5/8 Shaft

Model 6800A Dual wheel pivoting tongue jack, 1500 lb capacity. Two 6-inch wheels for added stability. 12 inches of travel, for tongues up to 28 inches from the ground. Zinc TUFFPLATE finish. Fits tongues up to 3 x 5 inches.

Zinc die-cast top cap with 1 inch NPT pipe fittings. For use with models 495 and 496 fuel filters only. Note: NOT FOR USE WITH BIODIESEL (see 470-1N).

Model 6339 4-1/4 in. x 3 in. Ribbed Rocker Roller-Fits 7/8 in. shaft.