Dutton-Lainson Company

20 foot extra heavy duty winch strap with hook, with breaking strength of 4800 lbs, for winches up to 3200 lbs (strap rating must be 150% of winch rating). 2 inch width, includes mounting hardware.

120 Volt Electric Winch has 10 foot, 3 wire grounded power cord. Power in, power out, controlled freewheeling clutch, and automatic brake. Comes loaded with 50 ft of 3/16 aircraft cable, pulley block, and snap hook. 1800 lb capacity when double-lined. Emergency crank handle also included in case of power loss. For applications with access to AC power: Boat lifts; Boat davits; Frame-straightening machines (to pull disabled vehicles up onto machine); Light towers; Marine railway systems; Greenhouse ventilation systems; Aircraft hangars (to pull small aircraft in and out); Opening/closing large horizontal sliding doors; Dumb waiters; General material handling applications. What makes StrongArm® electric winches different? Design: -is more compact, allowing it to fit into tight spaces. -is safer, as cable is enclosed inside the cover. On open-reel models, fingers can get caught in cable as it’s reeled in, and any frayed strands can cause cuts. -protects cable, so it’s not exposed to the elements, which accelerates wear and rusting. Unique features: -Clutch release. User can pay out load in neutral and still control it with clutch mechanism. -Spur gear system vs. planetary gears. A planetary gear system generates much more heat, and draws more amps from the power source. Because the motor and gears are attached directly to the spool, the heat build-up from running the winch transfers directly to the drum and cable. In contrast, the StrongArm winch’s spur gear system is much more efficient, it gives off less heat and draws fewer amps. NOTE: THIS WINCH IS BUILT FOR HORIZONTAL PULLING. FOR VERTICAL LIFTING APPLICATIONS, WE RECOMMEND ORDERING A WINCH WITH NO CLUTCH INSTALLED. PRICE IS THE SAME. NOTE: MAXIMUM RUN TIME 3 MINUTES. SEE OWNERS MANUAL FOR MORE DETAILS.

Similar to 25707, but NO CLUTCH, so no freewheeling capability. Suitable for short-distance vertical lifting applications not involving people, or loads over where people could be present. NOTE: MAXIMUM RUN TIME 3 MINUTES. SEE OWNERS MANUAL FOR MORE DETAILS.

Replacement wheel for the DLx-P and DLx-SW tongue jacks. 8 inch diameter, 3 inches wide. Includes axle bolt, sleeve, and nut.

Model 6347 3 in. Bow Roller - Fits 1/2 in. Shaft

Zinc top cap with 3/4 inch NPT fittings. For use with models 495 and 496 See-Thru fuel filters only. NOTE: NOT FOR USE WITH BIODIESEL (see 470-3/4N).

Replacement articulating foot for the DLx-SF tongue jack. Includes bolt, spring, and nut.

Combines the safety of a brake winch with a convertible handle option. The included Quick-Attach handle allows easy change between your right or left hand. 1500 lb capacity, zinc TUFFPLATE finish. 75 lb minimum load required for winch to operate properly.