1500 lb worm gear winch with regular drum, and handle drive. Reel automatically stops turning whenever cranking is stopped, locking load in place. Powder coated copper bronze finish, permanently lubricated bearings. Handle included. Will hold up to 81 ft of 3/16 cable, or 61 ft of 7/32 cable, or 43 ft of 1/4 cable. Cable sizes smaller or larger than these are not recommended.

3/4 inch spindle O.D., 1.781 outer hub I.D. Cone nbr LM11949, cup nbr LM11910. Includes 2 bearings with races, 1 grease seal, cotter pin and dust cap. IMPORTED.

DLx-SW swivel tongue jack with 1700 lb capacity. U.S.-made square tubing. Charcoal gray inner and outer square tubes over zinc TUFFPLATE finish. 12 inches of travel. Heavy-duty 3 in wide, 8 in diameter slotted independent wheel (wheel bracket rotates independent from inner post) for maximum maneuverability, particularly in sand or gravel. Reinforced wheel bracket also adds strength. Dual grease fittings keep interior parts fully lubricated. Premium handle cover and grip is softer and fits your hand better. Drainage holes near bottom of inner post. Bushing between tubes prevents scratching and tightens fit. Vinyl sleeve on 1/2 in swivel pin makes swiveling more comfortable, and pin rotates 90 degrees then back into recessed storage position. Jack rotates easily to horizontal towing position and locks in place. Fits tongues up to 3 x 5 in. Pair with a DLxFC pulling winch to make the ultimate trailering statement.

Model 6620 Ag-Industrial jack, side wind, with 10 inch travel. Includes weld-on mounting tube, and detent pin. 2000 lb capacity. Powder coated black finish.

Pulley block with swivel hook, for use in double line operation of electric winches. Will accept cable sizes up to 3/8".

Model 6390 Coupler Ball, fits 2 inch ball, with 2 inch HI-RISE for use with low vehicles. Shank is 1 inch diameter, 1-13/16 in. long. Polished chrome.

Replacement spout for 120-series GOLDENROD oilers.

GOLDENROD 400 fence stretcher makes repairs easy. Quickly tighten any fence - high tensile, barbed or smooth wire. Splice, stretch and reposition wire. When splicing wire, the tool holds the ends in place so both hands are free to make the splice. U.S. Design Pat. D457,413 S