Dutton-Lainson Company

25 foot heavy duty winch strap with hook, with breaking strength of 4000 lbs, for winches up to 2600 lbs (strap rating must be 150% of winch rating). 2 inch width, includes mounting hardware.

12 Volt Electric Winch with factory-installed remote control (handheld pendant switch with 10 ft cord) is powered by your vehicle battery, using wiring harness (included). Power in, power out, controlled freewheeling clutch, and automatic brake. Comes loaded with 50 ft of 3/16 aircraft cable, pulley block and snap hook. 2200 lb load capacity when double-lined. Emergency crank handle also included in case of power loss. DC Winches are great for mobile applications, or around water. Mount on ATV’s; Race car trailers (also for moving extra tires); Antique car trailers; Boat trailers; Hay bale moving; Livestock feeding equipment; Large livestock trailers; Boat lifts; Articulating conveyors. What makes StrongArm® electric winches different? Design: -is more compact, allowing it to fit into tight spaces. -is safer, as cable is enclosed inside the cover. On open-reel models, fingers can get caught in cable as it’s reeled in, and any frayed strands can cause cuts. -protects cable, so it’s not exposed to the elements, which accelerates wear and rusting. Unique features: -Clutch release. User can pay out load in neutral and still control it with clutch mechanism. -Spur gear system vs. planetary gears. A planetary gear system generates much more heat, and draws more amps from the power source. Because the motor and gears are attached directly to the spool, the heat build-up from running the winch transfers directly to the drum and cable. In contrast, the StrongArm winch’s spur gear system is much more efficient, it gives off less heat and draws fewer amps. NOTE: THIS WINCH IS BUILT FOR HORIZONTAL PULLING. FOR VERTICAL LIFTING APPLICATIONS, WE RECOMMEND ORDERING A WINCH WITH NO CLUTCH INSTALLED. PRICE IS THE SAME. NOTE: MAXIMUM RUN TIME 4 MINUTES. SEE OWNERS MANUAL FOR MORE DETAILS.

Similar to 25720, but NO CLUTCH, so no freewheeling capability. Suitable for short-distance vertical lifting applications not involving people, or loads over where people could be present. NOTE: MAXIMUM RUN TIME 4 MINUTES. SEE OWNERS MANUAL FOR MORE DETAILS.

Brake winch safety and rugged construction at a more economical price. Raise and lower loads with minimal effort, with load locked in place, even when handle is released. 1500 lb capacity, powder coated copper bronze finish. 75 lb minimum load required for winch to operate properly. Handle included.

Model 6343 5 In Spool Roller - Fits 5/8 Shaft

Model 6800A Dual wheel pivoting tongue jack, 1500 lb capacity. Two 6-inch wheels for added stability. 12 inches of travel, for tongues up to 28 inches from the ground. Zinc TUFFPLATE finish. Fits tongues up to 3 x 5 inches.

Zinc die-cast top cap with 1 inch NPT pipe fittings. For use with models 495 and 496 fuel filters only. Note: NOT FOR USE WITH BIODIESEL (see 470-1N).

Model 6339 4-1/4 in. x 3 in. Ribbed Rocker Roller-Fits 7/8 in. shaft.

Class 4 (6000 lb) coupler with pin & chain, fits 3 inch tongue. Zinc TUFFPLATE finish.

Combines the safety of a brake winch with the convenience of being able to freewheel when needed. When freewheel lever is engaged, cable can be pulled off manually, to save time. When lever is disengaged, braking mechanism takes effect to lock load in place, even when handle is released. 1500 lb capacity, zinc TUFFPLATE finish. 75 lb minimum load required for winch to operate properly. Handle included.

Model 6338 4-1/4 in. x 4-1/4 in. Rocker Roller - Fits 3/4 in. shaft.

1-3/8 x 1-1/16 inch spindle O.D., 1.98 outer hub I.D. Cone nbr L44649/L68149, cup nbr L44610/L68111. Includes 2 bearings with races, 1 grease seal, and cotter pin. IMPORTED.

Heavy duty carrier extends spare tire at an angle to avoid damage or marring of boat finish. Fits wheel sizes from 13-15 inches, 5-hole rims and trailer tongues up to 3 x 5 inches. Zinc TUFFPLATE finish.

Features heavy-duty 8 inch slotted wheel, to maneuver over rough terrain when moving trailer manually. Reinforced wheel bracket also adds strength. 4-bolt swivel mounting system for heavier applications. Zinc TUFFPLATE finish. 1500 lb capacity. Fits tongues up to 3 x 5 inches.

Fits model TW4000 from 2014-present. 25 ft power cable, 8 ft ground cable. #12 wire with 40 amp circuit breaker.

20 foot extra heavy duty winch strap with hook, with breaking strength of 4800 lbs, for winches up to 3200 lbs (strap rating must be 150% of winch rating). 2 inch width, includes mounting hardware.

120 Volt Electric Winch has 10 foot, 3 wire grounded power cord. Power in, power out, controlled freewheeling clutch, and automatic brake. Comes loaded with 50 ft of 3/16 aircraft cable, pulley block, and snap hook. 1800 lb capacity when double-lined. Emergency crank handle also included in case of power loss. For applications with access to AC power: Boat lifts; Boat davits; Frame-straightening machines (to pull disabled vehicles up onto machine); Light towers; Marine railway systems; Greenhouse ventilation systems; Aircraft hangars (to pull small aircraft in and out); Opening/closing large horizontal sliding doors; Dumb waiters; General material handling applications. What makes StrongArm® electric winches different? Design: -is more compact, allowing it to fit into tight spaces. -is safer, as cable is enclosed inside the cover. On open-reel models, fingers can get caught in cable as it’s reeled in, and any frayed strands can cause cuts. -protects cable, so it’s not exposed to the elements, which accelerates wear and rusting. Unique features: -Clutch release. User can pay out load in neutral and still control it with clutch mechanism. -Spur gear system vs. planetary gears. A planetary gear system generates much more heat, and draws more amps from the power source. Because the motor and gears are attached directly to the spool, the heat build-up from running the winch transfers directly to the drum and cable. In contrast, the StrongArm winch’s spur gear system is much more efficient, it gives off less heat and draws fewer amps. NOTE: THIS WINCH IS BUILT FOR HORIZONTAL PULLING. FOR VERTICAL LIFTING APPLICATIONS, WE RECOMMEND ORDERING A WINCH WITH NO CLUTCH INSTALLED. PRICE IS THE SAME. NOTE: MAXIMUM RUN TIME 3 MINUTES. SEE OWNERS MANUAL FOR MORE DETAILS.

Similar to 25707, but NO CLUTCH, so no freewheeling capability. Suitable for short-distance vertical lifting applications not involving people, or loads over where people could be present. NOTE: MAXIMUM RUN TIME 3 MINUTES. SEE OWNERS MANUAL FOR MORE DETAILS.

Replacement wheel for the DLx-P and DLx-SW tongue jacks. 8 inch diameter, 3 inches wide. Includes axle bolt, sleeve, and nut.

Model 6347 3 in. Bow Roller - Fits 1/2 in. Shaft

Zinc top cap with 3/4 inch NPT fittings. For use with models 495 and 496 See-Thru fuel filters only. NOTE: NOT FOR USE WITH BIODIESEL (see 470-3/4N).

Replacement articulating foot for the DLx-SF tongue jack. Includes bolt, spring, and nut.

Combines the safety of a brake winch with a convertible handle option. The included Quick-Attach handle allows easy change between your right or left hand. 1500 lb capacity, zinc TUFFPLATE finish. 75 lb minimum load required for winch to operate properly.