Dutton-Lainson Company

Combines the safety of a brake winch with the convenience of being able to freewheel when needed. When freewheel lever is engaged, cable can be pulled off manually to save time. When lever is disengaged, braking mechanism takes effect to lock load in place, even when handle is released. 1200 lb capacity, zinc TUFFPLATE finish. 50 lb minimum load required for winch to operate properly. Handle included.

1100 lb winch for horizontal pulling applications. High carbon steel gears, permanently lubricated bearings, ergonomic handle grip. Zinc TUFFPLATE finish. Handle included.

Roller bunk bracket, for mounting galvanized models 6387/6388. Zinc TUFFPLATE finish. Sold and priced individually. 4 needed to mount a pair of roller bunks. Allows bunks to be adjusted vertically and angled to cradle the boat hull.

1-1/16 x 3/4 inch spindle O.D., 1.781 outer hub I.D. Cone nbr LM11949/L44649, cup nbr LM11910/L44610. Includes 2 bearings with races, 1 grease seal, and cotter pin. IMPORTED.

Extends spare tire up and away from trailer and boat. Heavy-duty steel construction, fits wheel sizes from 9-14 inches, 4 or 5-hole rims and trailer tongues up to 3 x 5 inches. Mounting hardware included. Powder coated black finish.

Replacement wheel for 1250 lb jack models 6814, 6815, and 6817. Also fits 6613A removable wheel assy for A-frame jacks. Includes axle bolt, sleeve and nut.

Model 6675 Ag-Industrial jack, 5000 lb capacity, top wind, with 15 inch travel. Includes weld-on mounting tube, and detent pin. Powder coated black finish.

20 foot heavy duty winch strap with hook, with breaking strength of 4000 lbs, for winches up to 2600 lbs (strap rating must be 150% of winch rating). 2 inch width, includes mounting hardware.

12 Volt Electric Winch is powered by your vehicle battery, using wiring harness (included). Power in, power out, controlled free wheeling clutch, and automatic brake. Comes loaded with 50 ft of 3/16 aircraft cable, pulley block and snap hook. 2200 lb load capacity when double-lined. Emergency crank handle also included in case of power loss. DC Winches are great for mobile applications, or around water. Mount on ATV’s; Race car trailers (also for moving extra tires); Antique car trailers; Boat trailers; Hay bale moving; Livestock feeding equipment; Large livestock trailers; Boat lifts; Articulating conveyors. What makes StrongArm® electric winches different? Design: -is more compact, allowing it to fit into tight spaces. -is safer, as cable is enclosed inside the cover. On open-reel models, fingers can get caught in cable as it’s reeled in, and any frayed strands can cause cuts. -protects cable, so it’s not exposed to the elements, which accelerates wear and rusting. Unique features: -Clutch release. User can pay out load in neutral and still control it with clutch mechanism. -Spur gear system vs. planetary gears. A planetary gear system generates much more heat, and draws more amps from the power source. Because the motor and gears are attached directly to the spool, the heat build-up from running the winch transfers directly to the drum and cable. In contrast, the StrongArm winch’s spur gear system is much more efficient, it gives off less heat and draws fewer amps. NOTE: THIS WINCH IS BUILT FOR HORIZONTAL PULLING. FOR VERTICAL LIFTING APPLICATIONS, WE RECOMMEND ORDERING A WINCH WITH NO CLUTCH INSTALLED. PRICE IS THE SAME. NOTE: MAXIMUM RUN TIME 4 MINUTES. SEE OWNERS MANUAL FOR MORE DETAILS.

GOLDENROD heavy duty pump oiler, built to last. Precision machined, replaceable parts throughout; screw cap filler opening, interchangeable spouts, zinc die-cast high pressure pump with precision machined piston. Delivers a drop or stream of oil and stays primed for instant use. Powder coated copper bronze finish. 24 oz size, with 9-1/2 inch straight spout.

Model 6378 Wire & plug replacement kit, for 6367 remote. Replaces the switch-to-winch wire assembly. Normally used with model SA9005 Bale Spike Winch with in-cab remote.

40-mesh stainless steel strainer can be used in place of regular element to filter larger particles (381 microns). Can be rinsed and re-used. Fits See-Thru fuel filters only. Individually boxed.

Similar to 25700, but NO CLUTCH, so no freewheeling capability. Suitable for short-distance vertical lifting applications not involving people, or loads over where people could be present. NOTE: MAXIMUM RUN TIME 4 MINUTES. SEE OWNERS MANUAL FOR MORE DETAILS.

Model DL1100A Winch, with Heavy Duty Strap (15 ft.) Installed, Plated, Single Pack Handle included.

Replacement roller for both standard black and deluxe galvanized roller bunks. 2-1/4" x 1-3/8".

80-mesh stainless steel strainer can be used in place of regular element to filter large particles (178 microns). Can be rinsed and re-used. Fits See-Thru fuel filters only. Individually boxed.

Brake winch safety and rugged construction at a more economical price. Raise and lower loads with minimal effort, with load locked in place, even when handle is released. 1500 lb capacity, zinc TUFFPLATE finish. 75 lb minimum load required for winch to operate properly. Handle included.

1100 lb winch for horizontal pulling applications. High carbon steel gears, permanently lubricated bearings, ergonomic handle grip. Powder coated copper bronze finish. Handle included.

Model 6340 4 in. Spool Roller - Fits 5/8 in. Shaft

1-1/4 x 3/4 inch spindle O.D., 1.781 outer hub I.D. Cone nbr LM11949/LM67048, cup nbr LM11910/LM67010. Includes 2 bearings with races, 1 grease seal, and cotter pin. IMPORTED.

Extends spare tire up and away from trailer and boat. Heavy-duty steel construction, fits wheel sizes from 9-14 inches, 4 or 5-hole rims and trailer tongues up to 3 x 5 inches. Mounting hardware included. Zinc TUFFPLATE finish.

Replacement wheel for 1500 lb jack models 6850 and 6851. Includes axle bolt, sleeve, and nut.

Class 3 (5000 lb) coupler with pin & chain, fits 3 inch tongue. Zinc TUFFPLATE finish.

Fits TW9000, as well as StrongArm models with remote installed. 25 ft power cable, 8 ft ground cable. #8 wire with 70 amp circuit breaker.