Dutton-Lainson Company

3000 lb 12V DC winch with factory-installed remote control (handheld pendant switch with ten ft cord) for boat trailer use. For boats up to 9000 lbs. Built to same high quality standards as regular SA-series StrongArm winches, but loaded with 2 inch x 20 foot web strap and hook. Power-in, power-out and freewheel operation, with dynamic brake as well as mechanical friction brake. Includes emergency crank handle in case of power loss. NOTE: Maximum run time 4 minutes. See owners manual for more details.

Mounting hardware for the DLx-SF and DLx-SW tongue jacks. Fits square tongues up to 3 x 5 inches.

1 inch Grease Keeper dust caps with grease zirk and pressure relief valve. Protects wheel bearings from water and dirt with a positive hub seal. Supplies a reserve of lubrication and has built-in positive relief. Longer time between periodic repacking of bearings. Protects and extends bearing life. Zirk permits frequent greasing and relief valve eliminates excess pressure on grease seal. No complicated moving parts or gaskets that require costly maintenance and replacements. Easily installed in seconds, no need to remove hubs. A positive hub seal minimizes water entry when wheels are submerged. Zinc plated finish. Includes two protectors, each with a vinyl cover. Also fits 1-1/16 inch spindles.

This kit allows you to mount your D-L tongue jack to a square tongue up to 3 x 6 inches. Simply attach the kit to the mounting plate on your jack, then use the bolts that were included with the jack to mount it to the tongue. The series of photos above show what is included, and how to install the extender kit.

7 inch replacement handle for DLB350A, DLB800A and DLB1200A brake winches. Ergonomic handle grip.

2500 lb 2-speed winch for horizontal pulling applications, with hand brake for manually-controlled load release. High carbon steel, heat-treated gears, permanently lubricated bearings, reversible ratchet, ergonomic handle grip. Quick-attach handle allows easy change from high speed to low gear, requiring less effort. Powder coated copper bronze finish, zinc TUFFPLATE hardware. Handle included.

1-1/4 inch Grease Keeper dust caps with grease zirk and pressure relief valve. Protects wheel bearings from water and dirt with a positive hub seal. Supplies a reserve of lubrication and has built-in positive relief. Longer time between periodic repacking of bearings. Protects and extends bearing life. Zirk permits frequent greasing and relief valve eliminates excess pressure on grease seal. No complicated moving parts or gaskets that require costly maintenance and replacements. Easily installed in seconds, no need to remove hubs. A positive hub seal minimizes water entry when wheels are submerged. Zinc plated finish. Includes two protectors, each with a vinyl cover.

Wheel lock fits 800 and 1000 lb. D-L jacks with 6 inch wheel. Grips wheel to eliminate wheel roll. Step on one end to lock, opposite end to release. Kit includes locking lever, cam and mounting bolt.