Dutton-Lainson Company

A combination of item 11002 (which will accept strap), and 11001 (which has a hex drive, to be operated with an electric drill). Reel has matching holes drilled in each side plate for mounting strap. Straps sold separately, see Hand Winch Accessories. Recommended strap is model 6249, 20 foot, item 24240. Handle included for when a drill is not available.

Brake winch safety and rugged construction at a more economical price. Raise and lower loads with minimal effort, with load locked in place, even when handle is released. 800 lb capacity, zinc TUFFPLATE finish. 50 lb minimum load required for winch to operate properly. Handle included.

Ground Fault Circuit Interrupter for 120 volt AC electric winch applications near water. 15 foot 14/3 cord, 15 amp, 125 volt. Breaker mounted 7-1/2 inches from plug.

15 foot winch strap with hook, with breaking strength of 2600 lbs, for DL1100A through DL1602A (strap rating must be 150% of winch rating). 2 inch width, includes 3/8 inch bolt and nut. Note: Installing strap on smaller winches DL600A and DL900A requires a 1/4 x 2.75 inch bolt, which is not included.

120 Volt Electric Winch has 10 foot, 3 wire grounded power cord. 1200 lb capacity. Power in, power out, controlled freewheeling clutch, and automatic brake. Comes loaded with 20 ft of 3/16 aircraft cable. Emergency crank handle also included in case of power loss. For applications with access to AC power: Boat lifts; Boat davits; Frame-straightening machines (to pull disabled vehicles up onto machine); Light towers; Marine railway systems; Greenhouse ventilation systems; Aircraft hangars (to pull small aircraft in and out); Opening/closing large horizontal sliding doors; Dumb waiters; General material handling applications. What makes StrongArm® electric winches different? Design: -is more compact, allowing it to fit into tight spaces. -is safer, as cable is enclosed inside the cover. On open-reel models, fingers can get caught in cable as it’s reeled in, and any frayed strands can cause cuts. -protects cable, so it’s not exposed to the elements, which accelerates wear and rusting. Unique features: -Clutch release. User can pay out load in neutral and still control it with clutch mechanism. -Spur gear system vs. planetary gears. A planetary gear system generates much more heat, and draws more amps from the power source. Because the motor and gears are attached directly to the spool, the heat build-up from running the winch transfers directly to the drum and cable. In contrast, the StrongArm winch’s spur gear system is much more efficient, it gives off less heat and draws fewer amps. NOTE: THIS WINCH IS BUILT FOR HORIZONTAL PULLING. FOR VERTICAL LIFTING APPLICATIONS, WE RECOMMEND ORDERING A WINCH WITH NO CLUTCH INSTALLED. PRICE IS THE SAME. NOTE: MAXIMUM RUN TIME 3 MINUTES. SEE OWNERS MANUAL FOR MORE DETAILS.

Similar to item 14914, but has handle on LEFT side rather than right like on most winches. For situations where having the handle in the regular orientation will not work. Raise and lower loads with minimal effort. 800 lb capacity, zinc TUFFPLATE finish. 50 lb minimum load required for winch to operate properly. Special order item, please allow an extra 2-3 days. Handle included.

Similar to 25505, but NO CLUTCH, so no freewheeling capability. Suitable for short-distance vertical lifting applications not involving people or loads over where people could be present. NOTE: MAXIMUM RUN TIME 3 MINUTES. SEE OWNERS MANUAL FOR MORE DETAILS.

Brake winch safety and rugged construction at a more economical price. Raise and lower loads with minimal effort, with load locked in place, even when handle is released. 800 lb capacity, powder coated copper bronze finish. 50 lb minimum load required for winch to operate properly. Handle included.